Our custom grind on new billets.

This #435 race only grind intake cam is as strong as it gets.  It falls off some from 5000 to 6800 compared to the #440 11.6mm (as intake cam), but makes it up on the top end, going all the way to 8300.  It pulls harder and longer.

NOTE:  We strongly recommend our VSS12-14 valve spring for our13mm lift cams, especially for sustained high RPM..

• Combined with a #440 11.6mm exhaust cam, it makes all the power available from any Alfa engine.
• Combined with our #420 11.1mm as exhaust cam, it retains more of the back end power with minimal sacrifice on top end.
• Base circle is .960" on our 13mm cams.
• We will custom grind to your specified base circle.  Add $10.00.

CAUTION: This is not a bolt in cam.  It interferes with cam follower bores and coil binds most spring setups.  Total duration: 320 degrees at .011"; 270 degrees at .050" lift.

Click here to see our #420, 11.0mm lift cam.

Click here to see our #440, 11.6mm lift cam.